High adhesion 2-component epoxy water primer. Suitable for surface preparation to be applied after the final layer of epoxy water paint. Ideal for interior metal surfaces, concrete floors, cementitious substrates, etc. Certified according to CE EN 1504-2
, 
, 
, 
EPOXY PRIMER 2K-WATER
epoxy waterbased primer 2k
Packaging:
4.5kg, 22kg
Finish:
Shades:
Available in white and gray
Technical Information
DILUTION:
5-10% water
COVERAGE:
5-7m2 / kg per layer on properly prepared surfaces
DRYING:
1-2 hours according on weather conditions
Files
Technical data sheet
Application Tools
SURFACE PREPARATION
To ensure proper adhesion of the product, the painted surface must be cleaned of dust, grease, oil, peeled old paint, rust, mold or moisture residue.
Mix component A and B with a low speed stirrer for 2-3 minutes. Leave the mixture and then repeat the stirring. The entire amount of A with B component must be stirred in the proportion given.
If a smaller amount is to be applied then the ingredients need to be weighed in the same weight ratio, at a ratio of 3: 1 by volume with good agitation.
Dilute the product with water at a rate of 5-10% for the desired workability
Applied in one or two coats on dry, clean surfaces free of dust, loose and loose particles which prevent the product from sticking
The product acquires all its mechanical strength after 20 – 30 days.
Caution: if we mix component A and B the product can not be stored and reused.
Avoid applying the product at temperatures below 6 ° C and above 40 ° C and when the relative humidity is greater than 80%. Adverse conditions during application may alter the final properties of the product.
CAUTION: Wear protective gloves / protective clothing / eye / face protection. In case of contact with eyes, rinse thoroughly with plenty of water for several minutes. If there are contact lenses, remove them if they are easy. Keep rinsing.
Immediately call the POISON CENTER or your doctor
